![]() ![]() You can also check for clipping by choosing View > Show Clipping from the menu. ![]() You will need to zoom in to inspect the waveform as closely as this, but extended lengths of clipping will also be visible at lower zoom levels.Ī properly recorded waveform A clipped waveform The illustrations below show about 0.004 seconds of a properly recorded waveform then a clipped waveform. The result is that the tops and bottoms of the recorded wave are chopped off ("clipped"). ![]() Clipping is bad - this is when the volume of the source sent to Audacity is louder than Audacity can record. Have a look at the recorded waveform - there should be no clipping visible. Record for long enough to find the loudest likely part, then click the Stop button. Start the audio playing on the computer then click the Record button in Transport Toolbar. Make a test recording to refine levels if necessary. It may be best to check that the Audacity playback slider and the website or player slider are turned up by about the same amount, rather than having one output slider way down and the other way up. Thus to achieve the correct recording level you should use both the recording and playback level sliders on Mixer Toolbar:Īnd probably the volume control on the website or player software as well. See Meter Toolbars for a detailed description of what the meter display shows.īoth the output level of the audio you are recording and the level it is being recorded at will determine the achieved input level of the recording. You can always amplify the recorded signal later if necessary. The aim is to adjust levels so that the long colored bars in Meter Toolbar do not exceed about -9.0 to \xe2\x80\x936.0 dB (or 0.5 if the meters are set to linear rather than dB).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |